Meridian America Link/Customer Controlled Routing manual Installing Ethernet LAN support

256Chapter 9: Meridian Link/CCR interface cabling

7Power up the Application Module.

8Define the Meridian Mail Link parameters using Procedure 15 in Chapter 15, ÒLink configurationÓ in this guide.

Note: Return to Chapter 5, ÒHardware installation overviewÓ for the next procedure. For more information on Meridian Mail, refer to Chapter 13, ÒMeridian Mail configuration.Ó

Installing Ethernet LAN support

Hardware and software requirements for installing Ethernet LAN support are discussed in the ÒEthernet LAN-based PCÓ section in the Chapter 1, ÒMeridian Link/CCR co-residencyÓ. However, you should be aware of the following:

¥All IPE Modules can provide Ethernet LAN support

¥Application Modules can provide Ethernet LAN support only if they have the following:

Ñan MVME167-02 SBC card

Ñan MVME712M transition card

Ña generic I/O panel

Ñan NT7D47DA cable connected between the MVME712M card and the Ethernet port of the generic I/O panel (refer to Table 93 for the pinout of this cable)

Ñan NT7D47EA drop cable connected between the Ethernet port of the generic I/O panel and the Ethernet transceiver (refer to Table 94 for the pinout of this cable)

For more information about the NT7D47DA and the NT7D47EA cables, refer to Procedure 28: Installing the cables for Ethernet LAN support (Application Module) in Chapter 17, ÒHardware upgrade.Ó

553-3202-210 Standard October 1998