Meridian America Link/Customer Controlled Routing Enable Esdi port X81 phase 7 or X11 Release

302Chapter 12: Meridian 1 configuration for Meridian Link/CCR

Enable ESDI port (X81 phase 7 or X11 Release 17)

Commands in LD 48 require a port or link parameter, which is indicated in the prompts as xx. Substitute the appropriate port or link number when using the prompts listed below.

Table 107

LD 48ÑLink Diagnostic

Command Comment

ACMS xx Enable and start the ESDI link on port xx

The following commands may be used for diagnostic purposes:

CON ESDI xx	Configure link layer for ESDI port xx using HDLC
	protocol
DIS ESDI xx	Disable ESDI on port xx
DIS MSGI xx	Turn off link monitoring for incoming messages on
	link xx
DIS MSGO xx	Turn off link monitoring for outgoing messages on
	link xx
DSC ESDI xx	Disconnect the link to ESDI on port xx
ENL ESDI xx	Enable ESDI on port xx
ENL MSGI xx	Turn on link monitoring for incoming messages on
	link xx
ENL MSGO xx	Turn on link monitoring for outgoing messages on
	link xx
ENXP MSGO xx	Exclude polling on link xx for outgoing messages
yy	with priority levels yy
ENXP MSGI xx yy	Exclude polling on link xx for incoming messages
	with priority levels yy
ENL MSGI/MSGO	Enable message input/output monitoring (xx=link)
xx
	ÑcontinuedÑ

553-3202-210 Standard October 1998