Meridian America Link/Customer Controlled Routing manual Start-up interrupt menu

414Chapter 14: Software installation, upgrade, and update procedures

Procedure 5: Load the operating system tape on an Application Module with an MVME147 card (continued)

2Type h immediately, before the next prompt appears. (You have about five seconds to do this.)

3Write down the firmware release listed on the second message line. Figure 143, for example, shows Release 2.42. You will need this in step 12.

Figure 144

Start-up interrupt menu

1)Continue System Start-up

2)Select Alternate Boot Device

3)Go To System Debugger

4)Initiate Service Call

5)Display System Test Errors

6)Dump Memory to Tape

Enter Menu #:

4The menu in Figure 144 appears. Type 3 and press [Return] to enter the system debugger.

5At the Ò147-Diag>Ó prompt, type iot;t and press [Return].

The system performs a scan of disk/tape controllers (Figure 145).

Figure 145

Results of disk/tape controller scan

Scanning system for available				disk/tape		controllers
Disk Controllers Available
LUN	Type	Address	# dev
0	VME147	$FFFE4000	1	SCSI	Addr	= 0	- FUJITSU	M2614S	M606
1	VME147	$FFFE4000	1	SCSI	Addr	= 4	- TEAC	MT-2ST/N50	RV F
	VME147	$FFFE4000	*	SCSI	Addr	= 7
Align	LUNs to	SCSI addresses [Y,N]			N?

6Write down the type of disk drive installed in SCSI address 0. This information is required later in the procedure. (In the example shown above, the drive is a Fujitsu M2614S.)

7You are prompted to align LUNs. Type y and press [Return].

553-3202-210 Standard October 1998