Meridian America Link/Customer Controlled Routing manual CCR customer number prompt

466Chapter 14: Software installation, upgrade, and update procedures

Procedure 8: Load the application software from tape (continued)

If you have purchased CCR, go to step 20.

Figure 241

CCR customer number prompt

Please enter the CCR customer number (0-99):

20You are prompted to enter your CCR customer number (Figure 241). Type the number and press [Return].

Figure 242

Ethernet connection prompt

Installing NSE R3V7.1. Please wait.

Is your module connected to the Ethernet (y/n) ?

21You are asked whether your IPE Module or Application Module is connected to Ethernet (Figure 242).

Note: Your module must be connected to Ethernet before you type y.

For more information about Ethernet connections, refer to ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR interface cabling.Ó

If your module is not connected to Ethernet, type n and press [Return]. Go to step 25.

If you are connected to Ethernet and you plan to use it in the near future, type y and press [Return]. You see a message asking you to wait. Then you see more installation messages (Figure 243). Go to step 22.

If you are connected to Ethernet but do not plan to use it in the near future, you may choose to type n and press [Return]. Disabling Ethernet support increases the processing power available to your application(s). Go to step 25.

553-3202-210 Standard October 1998