Meridian America Link/Customer Controlled Routing manual Return, Environment prompts IPE Module

<cr>

<cr>

430Chapter 14: Software installation, upgrade, and update procedures

Procedure 6: Load the operating system tape on an IPE Module or an Application Module with an MVME167 card (continued)

4At the Ò4120-Diag>Ó or Ò4120-Bug>Ó prompt, type env and press [Return].

The environment prompts appear. Answer them as indicated in the following figure. Then go to step 6.

Figure 173

Environment prompts (IPE Module)

Bug or System environment [B/S] = B?

Field Service Menu Enable [Y/N] = N?

Probe System for Supported I/O Controllers [Y/N] = Y? <cr>

Local SCSI Bus Reset on Debugger Startup [Y/N] = Y? <cr>

Ignore CFGA Block on a Hard Disk Boot [Y/N] = Y? <cr>

Auto Boot		Enable [Y/N]	=	Y?	<cr>
Auto	Boot	at power-up only		[Y/N] = N? <cr>
Auto	Boot	Controller LUN	= 00?		. <cr> (Type a period and press
					[Return].)

If you make a mistake, quit the process by entering a period (.) at a prompt and answering n for the last two questions (Update Non- Volatile RAM/Reset Local System). This brings you back to the Ò167- Diag>Ó or Ò4120-Diag>Ó prompt. Then type env;d and press [Return] to undo the mistakes you made and bring back the original default values.

Note: At the ÒAuto Boot Controller LUN=00?Ó prompt, type a period and press [Return] to bypass additional prompts that do not need to be changed.

553-3202-210 Standard October 1998