Meridian America Link/Customer Controlled Routing manual Overview of hardware components

xviAbout this guide

Chapter 3: Overview of Customer Controlled Routing This chapter provides an overview of CCR, describes its concepts, and lists required hardware and software.

Chapter 4: Meridian Link/CCR hardware This chapter provides an

overview of hardware components.

Chapter 5: Hardware installation overview This chapter lists the tools and provides tables to describe the installation of an IPE Module or an Application Module.

Note: If you intend to install an IPE Module or an Application

Module, refer to Table 11 (IPE Module) or Table 12 (Application

Module) in this chapter.

Chapter 6: Site survey/installation checklist This chapter provides a checklist to ensure that all hardware and software requirements are met for a successful installation.

Chapter 7: Unpack and inspect hardware This chapter provides information on receiving, unpacking, and inspecting the IPE Module and Application Module hardware components.

Chapter 8: Hardware installation procedures This chapter contains all of the main hardware installation procedures, with references to surrounding chapters for further information.

Chapter 9: Meridian Link/CCR interface cabling This chapter describes the cabling requirements. Two following chapters describe how to set up terminals, and how to configure the Meridian 1 system.

Chapter 10: Installing peripheral devices This chapter describes the procedures for how to set up and configure video display terminals and printers supported by the Meridian Link and CCR appplications.

Chapter 11: Peripheral device cabling interface This chapter provides information on installing and configuring modems and the A/B switchbox.

Chapter 12: Meridian 1 configuration for Meridian Link/CCR This chapter shows how to use various software programs to configure the Meridian 1 to support Meridian Link and CCR.

553-3202-210 Standard October 1998