Meridian America Link/Customer Controlled Routing manual Software install messages

Chapter 14: Software installation, upgrade, and update procedures 467

Procedure 8: Load the application software from tape (continued)

ATTENTION

If you disable Ethernet support, you must perform a complete reinstallation of the base operating system and application(s) before you can reenable Ethernet support.

Note: A two-minute pause occurs at this point before the following messages shown in Figure 243 appear.

Figure 243

Software install messages 2

Configuring your system for NSE. Please wait. /usr/src/uts/m68k/sysgen/sysgen -l /usr/src/uts/m68k/sysgen -big

make -f io.mk MAKE=make FRC= DASHG= DASHO=-O INCRT=/usr/include LIBDIR=../cf SYS= CFLAGS= -O -I/usr/include -DLAI -DINKERNE

L -DSTREAMS -DBRIDGE CPU=m68k CC=/bin/pcc/cc

make -f scsi.mk "MAKE=make" "CC=/bin/pcc/cc" "FRC=" "INCRT=/usr/include" "DASHO=-O" "CFLAGS=-O -I/usr/include -DLAI -DINKER

.

.

.

Warning: ./config.h: 358: NBLK4 redefined rm -f sysV68 sysV68.nm

ld -o sysV68 ld.VME131 m68kvec.o low.o conf.o lib.io lib.ml lib.os lib.s5 lib.bpp lib.fpack lib.nosrc lib.fpsp lib.du lib.tc

pip lib.nfs lib.bppv2 lib.c37x lib.kdb lib.lnc lib.nsedebug lib.sbc lib.scsi lib.wan lib.x25 lib.stub lib.io lib.ml lib.os

lib.s5 lib.bpp lib.fpack lib.nosrc lib.fpsp lib.du lib.tcpip lib.nfs lib.bppv2 lib.c37x lib.kdb lib.lnc lib.nsedebug lib.sbc lib.scs

i lib.wan lib.x25 lib.stub

mcs -da "SYSTEM V/68 - R3V7" sysV68 chmod 755 sysV68

../kdb/kdbnm -q sysV68

../kdb/kdbnm: not enough space for symbol table

../kdb/kdbnm: need total of 145908 bytes at k_symtab

../kdb/kdbnm: 135168 bytes were reserved for symbols, 135168 bytes were used sysV68 made.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide