Meridian America Link/Customer Controlled Routing manual

Chapter 9: Meridian Link/CCR interface cabling 259

10At step 21 of Procedure 8, type the module address of the IPE Module or Application Module and press [Return]. There are specific requirements for the address. For more information, consult your network administrator.

If you are activating support for an Ethernet LAN-based PC, continue with steps 11-13.

11When you have completed Procedure 8, ensure that the Ethernet software has been installed on the LAN-based PC. The software must be installed with VT220 emulation. For more information about Ethernet software, refer to ÒEthernet LAN-based PCÓ in Chapter 1, ÒMeridian Link/CCR co-residencyÓ.

12At the PC, start a network session to the IPE Module or Application Module using the host name and address from steps 9 and 10 in this procedure. Refer to the documentation for the Ethernet software for the procedure.

13After the network session starts, you will receive a prompt to log in. You can now log in as ccrusr in the usual way to perform CCR user functions. Refer to the CCR User Guide for more information. Or you can log in as maint in the usual way to issue Application Module or link commands. Refer to the Application Module and Intelligent Peripheral Equipment Module Diagnostic and Maintenance Guide

(NTP 553-3211-510) for more information.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide