Meridian America Link/Customer Controlled Routing manual

Chapter 14: Software installation, upgrade, and update procedures 375

To configure the software after installing a new IPE Module or Application Module

The UNIX and application software are loaded onto the hard disk at the factory. Tapes containing the same software are shipped with your module as a backup. A blank tape is needed to back up configuration data and scripts.

When power is applied to the IPE Module or the Application Module, the system boots up from the software loaded on the hard disk. Power also activates the yellow LED on the SBC card in the IPE Module or the Application Module. As long as this LED blinks intermittently, the system is loading properly. If the LED remains dark or steadily lit (for 30 seconds or more), there is a fault in the installed cards.

To configure the software after installing a new IPE Module or Application Module

¥Perform Procedure 1: Application configuration and start-up, in this chapter.

¥Check that the values of the default link parameters match the values in Chapter 15, ÒLink configuration.Ó If you need to change any link parameters, perform the procedures described in Chapter 15, ÒLink configuration.Ó

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide