Meridian America Link/Customer Controlled Routing Meridian 1 configuration for Meridian Link/CCR

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 331

Note: The Unringing event is available only with X11 Release 19 and later software. X11 International Phase 7 software offers only four status change events.

¥Transfer completed to notifies the application when a DN has completed a transfer to another DN. This message is sent on behalf of the destination DN of the transfer, the party which had just received the transferred call. This message is supported for both analog and digital sets.

¥Conference completed to notifies the application when a DN has completed a conference to another DN. This message is sent on behalf of the destination DN of the conference, the party which is being conferenced into the call. This message is supported for both analog and digital sets.

¥Conference to simple notifies the application when a conference call reverts from a 3-party to a 2-party call. This message is sent on behalf of DNs that are monitored by the application. This message includes the DN and TN information of the two parties left in the conference call.

¥Hold notifies the application of when a DN has just put the active call on hold. The StatusChange hold notification message is sent to applications on behalf of digital and 500/2500 sets.

The StatusChange hold message is a notification of a set invoking hold. The ML Hold message to invoke the hold feature for digital and 500/2500 sets is developed in X11 Release 22.

The StatusChange hold message is sent when a call is put on hold. The automatic hold feature, an X81 feature, puts an active call on hold when another DN key is pressed on the set where an active call already exists. A StatusChange hold message is sent in this scenario.

¥Transfer initiation notifies the application when a transfer is initiated by or on behalf of a set. This feature is supported for digital sets only. If a 500/2500 set performs a switch-hook flash to initiate a transfer, the application receives a StatusChange hold message.

¥Conference Initiation notifies the application when a conference is initiated by or on behalf of a set. Conference initiation is supported for digital sets only. If a 500/2500 set performs a switch-hook flash to

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide