Meridian America Link/Customer Controlled Routing manual

Chapter 8: Hardware installation procedures 131

Table 31

MVME333-2 XCC card jumper settings

Block	Jumper setting
K1	2 and 4, 6 and 8, 10 and 12, 13Ð14, 15Ð16, 23Ð24
K2	none
K3	1Ð2, 5Ð6, 7Ð8, 9Ð10
K4	none
K5	1Ð2, 3Ð4
K6	5Ð6
K7	5Ð6
K8	none
K9	1Ð2

6Replace the MVME333-2 XCC card and replace the screws at the top and bottom of the faceplate.

7If you are checking the option settings for an Application Module installed on the left side of the AEM, go to step 5. If the Application Module is preinstalled on the right side of the AEM, remove it as follows:

¥If you have an I/O subpanel, loosen the five spring-loaded screws that hold the I/O subpanel to the I/O assembly of the AEM. Gently set the panel in the back of the Application Module so the cables do not come in contact with the edges of the AEM.

¥If you have a universal I/O panel or a generic I/O panel, remove the screws at the edges of the I/O panel. Gently set the panel in the back of the Application Module.

¥Detach the orange logic-return ground wire that is screwed to the terminal block at the bottom of the AEM.

¥Unplug the yellow and gray cable (NT7D52AA) that connects the power sense card to the power monitor.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide