Meridian America Link/Customer Controlled Routing manual Configure Esdi port X11 Release

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 299

Configure ESDI port (X11 Release 17)

The IPE Module or Application Module is connected to the Meridian 1 through a port on a QPC513 ESDI card (vintage G or later) or an NTAK02 SDI/DCH card (Option 11, IPE Module only). The port must have the AML identified (VSID 0Ð15). Define the ESDI port and its characteristics by responding to the following prompts in

LD 17.

Options 21Ð81 ESDI configuration

Table 106

LD 17ÑConfigure ESDI port (Options 21Ð81)

Prompt	Response	Comment
REQ	CHG	Create or change information in the
		database
TYPE	CFN	Configuration record data block
PWD2	<cr>
ISDN	<cr>
PARM	YES	Change a parameter
NCR	26Ð2047,	Increment the current value by the value
	5000	used for CSQI and CSQO. See those
		prompts described later in this table.
		Note: The Meridian 1 must be reinitialized if
		NCR is changed.
CEQU	<cr>
OVLY	<cr>
IOTB	YES	Change I/O terminals or devices
HIST	<cr>
ADAN	NEW TTY x	Add ESDI on port x
ESDI	YES	Port is on an ESDI card
SYNC	YES	Synchronous mode
		ÑcontinuedÑ

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide