Meridian America Link/Customer Controlled Routing manual Link configuration

Chapter 15: Link configuration 491

Procedure 14: Changing Meridian Link (link 1) parameters (continued)

Table 142

X.25 and LAPB parametersÑLink 1 (continued)

Link parameter	Allowed values	Description
	(defaults in parentheses)
Maximum Frame Length*	135
Baud rate	300 600 1200 2400 4800	Must be same as baud rate on the
	9600 (19200) 38400	Meridian 1 or host computer config-
	48000 56000 64000	uration; if modems are used, must
		also match baud rate of the modem
Fail timer	0-(50)Ð9999	Timer value (in 1/10 second
		increments) for monitoring the
		signals that indicate link failure
RFS timer	0Ð(150)Ð9999	Timer value (in 1/10 second
		increments) for monitoring CTS or
		DTR signals after line opening
Internal address	(1), 3	1 for DCE; 3 for DTE
Remote address	1, (3)	3 for DCE; 1 for DTE. (This value
		must be different from the value of
		the internal address. The
		combination of values for internal
		address and remote address must
		be the opposite of the values for
		the host. That is, if the values for
		the host are 3, 1, the values for the
		link must be 1, 3.)
T1	0Ð(20)Ð9999	Frame recovery time (in 1/10
		second increments); must be
		identical to the time specified on
		the host computer configuration
Maximum out frames (K)	1Ð(7)	LAPB window size; must be
		identical to the size specified on the
		host computer configuration
Note: Parameters marked with an asterisk (*) cannot be changed.
	Ñ continued Ñ

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide