Meridian America Link/Customer Controlled Routing Procedure 3 Load application software from tape

404Chapter 14: Software installation, upgrade, and update procedures

Procedure 3: Load application software from tape (continued)

10If you are activating the Meridian Link application, you are prompted to enter the Meridian Link protocol.

If you are using the X.25 protocol, type x, press [Return], then go to step 13.

If you are using the TCP/IP protocol, press [Return], then go to step 11.

Figure 128

IP address prompt

Meridian Link using a TCP/IP connection.

If you would like a default gateway IP address configured or changed, please enter the IP address in internet dot notation (e.g. 47.82.45.10). For no change enter <cr>:

11To configure or change a default gateway IP address, type the IP address in the proper format and press [Return]. If no modification or configuration is required, simply press [Return].

Figure 129

Subnet mask prompt

Saving default gateway IP address:

If you would like a default subnet mask configured or changed,

please enter the subnet mask (e.g. 255.255.0.0). For no change enter <cr>:

12To configure or change a default subnet mask, type the subnet mask address in decimal format and press [Return]. If no modification or configuration is required, simply press [Return].

553-3202-210 Standard October 1998