Meridian America Link/Customer Controlled Routing manual Configuration overview

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 295

Configuration overview

Install or upgrade the Meridian 1 to the appropriate software release (see

Chapter 2, ÒOverview of Meridian LinkÓ or Chapter 3, ÒOverview of

Customer Controlled RoutingÓ). To upgrade an existing system, refer to

Software Conversion Procedures (NTP 553-2001-320).

Summary of Meridian 1 configuration

1Define the ESDI/MSDL, STA, and SDI ports in the Configuration Record (LD 17).

Ensure that you refer to the prompts for your release of X11 software (either Release 17 or later).

2Identify VASID and define the status message groups in LD 15.

3Define ACD groups and agents in Automatic Call Distribution (LD 23) if required for the application.

4Configure single-line telephones with the Associated Set (AST) and Unsolicited Status Messages (USM) features in Single-Line Telephone Administration (LD 10).

5Configure multi-line telephones with the AST and USM features in Multi-Line Telephone Administration (LD 11).

6Configure Control DNs (CDNs) in LD 23 if required for Host Enhanced Routing.

7Enable the ESDI/MSDL port in Link Diagnostic (LD 48).

8Enable the SDI port for console sharing in Input/Output Diagnostic (LD 37).

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide