Meridian America Link/Customer Controlled Routing specs

130Chapter 8: Hardware installation procedures

If your Application Module does not have CCR activated, the MVME332XT(S) card may not be present. If so, skip steps 1Ð3 and begin at step 4.

1Remove the screws at the top and bottom of the MVME332XT(S) card faceplate.

2Pull the MVME332XT(S) card out of the Application Module. Check the switches as indicated in Tables 29 and 30.

Table 29

MVME332XT ACC card switch settings

				Position
Switch	1	2	3	4	5	6	7	8

S1	on	off	off	off	off	on	on	on
S2	off	off	on	on

Table 30
MVME332XT ACC card jumper settings

Block				Jumper setting

J1	1Ð2, 5Ð6, 7Ð9, 8Ð10, 11Ð12, 15Ð17
J4	1Ð2

3Replace the MVME332XT(S) card and replace the screws at the top and bottom of the faceplate.

4Remove the screws at the top and bottom of the MVME333-2 XCC card faceplate.

5Pull the MVME333-2 XCC card out of the Application Module. Check the switches as indicated in Table 31 and Figure 34.