Meridian America Link/Customer Controlled Routing manual Environment prompts appear

<cr>Ê

416Chapter 14: Software installation, upgrade, and update procedures

Procedure 5: Load the operating system tape on an Application Module with an MVME147 card (continued)

Figure 148

SCSI bus reset prompts

Reset Local SCSI Bus			(Y,	N)		N?	y <cr>
Automatic	reset	of known		SCSI		Buses on RESET (Y, N) = Y? <cr>
Cold/Warm	Reset	flag	(C,	W)	=	C?	<cr>
Execute Soft Reset (Y, N)					N?	<cr>

11When the Ò147-Diag>Ó prompt appears, type env and press [Return].

The environment prompts appear.

12Answer the prompts as indicated in Figures 149, 150, or 151, depending on the firmware installed in your system. The firmware release appeared in the start-up messages shown in step 3.

Figure 149

Environment prompts for firmware revision 2.2

Bug or System environment [B,S] = S? <cr>

SYSTEM V/68 or VERSAdos operating system [S,V] = S? <cr>

Execute/Bypass SST Memory test [E,B] = E? b <cr>

Set VME Chip:

Board ID [0-FF] = $00? <cr>

GCSR base address [0-0F] = $0F? <cr>

Utility Interrupt Mask [0-FE] = $00? <cr>

Utility Interrupt Vector [$20-$30] = $0180? <cr>

Figure 150

Environment prompts for firmware revision 2.3

Bug or System environment [B,S] = S? <cr>

Execute/Bypass System Memory Sizing [E,B] = B?

Execute/Bypass SST Memory test [E,B] = B? <cr>

Set VME Chip:

Board ID(def is 0) [0-FF] = $00? <cr>

GCSR base address offset(def is 0F) [0-0F] = $0F? <cr>

Utility Interrupt Mask(def is 0) [0-FE] = $00? <cr>

Utility Interrupt Vector number(def is 60) [8-F8] = $60? <cr>

VMEbus Interrupt Mask(def is FE) [0-FE] = $FE? <cr>

553-3202-210 Standard October 1998