Meridian America Link/Customer Controlled Routing Link configuration, Default configuration, 479

479

Chapter 15: Link configuration

This chapter describes the initial configuration procedures for the links used by the applications, and refers to the procedures in Chapter 14, ÒSoftware installation, upgrade, and update proceduresÓ earlier in this guide.

Note: The redundancy feature does not affect link configurations as described in this chapter.

Default configuration

Systems shipped from the factory are configured as described in the following sections. The default configuration for link 0 applies to Meridian Link, CCR, and co-resident systems. Configurations for link 1 and link 2 are for Meridian Link and co-resident systems only.

Link 0ÑApplication Module Link

Link 0 is defined as the Application Module Link (AML), with the following characteristics (which are described in more detail later in this chapter):

Protocol: HDLC	Link type: 1
Machine ID: SL16
Delay: 0
Port type: H	Physical DTE(0)/DCE(1): 0
PDN type: 0	Maximum Frame length: 135
Baud rate: 19200	Fail timer: 50
RFS timer: 150	Internal address: 1
Remote address: 3	T1: 20
Maximum out frames (K): 7	Maximum trans attempts: (N2): 8

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide