Meridian America Link/Customer Controlled Routing manual

382Chapter 14: Software installation, upgrade, and update procedures

Section 7: To update Meridian Link from Release 5 to Release 5C

When you update Meridian Link from Release 5 to Release 5C, the release or issue of the BOS changes.

¥Perform Procedure 2: Start the update process.

¥Depending on the type of SBC card installed, perform one of the following:

ÑProcedure 5: Load the operating system tape on an Application Module with an MVME147 card

ÑProcedure 6: Load the operating system tape on an IPE Module or an Application Module with an MVME167 card

¥Perform Procedure 7: Reboot and go through setup.

¥Perform Procedure 8: Load the application software from tape.

¥Perform Procedure 9: Restore configuration files and data files from the backup tape to customize your system.

¥Perform Procedure 10: Verify the installation to confirm that the installation is complete and correct.

¥Perform Procedure 11: Back up configuration files and data files to back up the customized new release.

Section 8: To update Meridian Link from Release 5 to Co-residency

If you have Meridian Link Release 5 and want to upgrade to co-residency, you must install the application. Then you must enter a keycode to activate CCR and Meridian Link.

To do this:

¥Perform Procedure 2: Start the update process.

¥Perform Procedure 3: Load the application software from tape.

553-3202-210 Standard October 1998