Meridian America Link/Customer Controlled Routing manual Autoboot enable prompts

Chapter 14: Software installation, upgrade, and update procedures 415

Procedure 5: Load the operating system tape on an Application Module with an MVME147 card (continued)

Figure 146

Disk/tape controller list after aligning LUNs

Disk	Controllers Available
LUN	Type	Address	# dev
0	VME147	$FFFE4000	1	SCSI Addr = 0 - FUJITSU M2614S	M606
1	VME147	$FFFE4000	1	SCSI Addr = 1
2	VME147	$FFFE4000	1	SCSI Addr = 2
3	VME147	$FFFE4000	1	SCSI Addr = 3
4	VME147	$FFFE4000	1	SCSI Addr = 4 - TEAC MT-2ST/N50 RV F
5	VME147	$FFFE4000	1	SCSI Addr = 5
6	VME147	$FFFE4000	1	SCSI Addr = 6
	VME147	$FFFE4000	*	SCSI Addr = 7
Save	map in NVRAM [Y,N] N?

8The LUN results appear (Figure 146). Type y and press [Return] to save the map in non-volatile memory.

9The 147-Diag> prompt reappears. Type ab and press [Return] to set autoboot enable.

Autoboot enable prompts appear. Answer them as indicated below.

Figure 147

Autoboot enable prompts

Controller LUN = 00? <cr>

Device LUN = 00? <cr>

Default String = ? <cr>

Boot at Power-up only or any board Reset [P,R] = R? <cr>

On any board Reset:

Auto Boot from Controller 0, Device 0

10At the Ò147-Diag>Ó prompt, type reset and press [Return].

The SCSI bus reset prompts appear. Answer them as indicated in the following figure.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide