Meridian America Link/Customer Controlled Routing manual

Chapter 14: Software installation, upgrade, and update procedures 465

Procedure 8: Load the application software from tape (continued)

Figure 240

List verification prompt

Saving default subnet mask:

The following applications are configured:

Meridian Link

Large CCR

The following packages are configured: 1 96 97 98 99 100 101

Ethernet NSE software is enabled.

Is this correct (y/n/q)?

The system lists the application or applications installed.

Note: Figure 240 only shows applications that have been selected; they are actually enabled when the system reboots at the end of this procedure.

To check that the correct application has, or applications have, been installed, refer to the checklist (Table 17) you completed in the ÒIPE Module and Application Module: Meridian Link/CCR softwareÓ section in Chapter 6, ÒSite survey/installation checklist.Ó

19The system prompts you to verify that the list is correct.

If the list is incorrect, type n and press [Return]. You are returned to step 10. Rekey your Meridian ID and keycode. If the list of applications is still incorrect, type q and press [Return]. The message ÒSoftware not configuredÓ appears. Call your Nortel support personnel for a new keycode.

If the list is correct, type y and press [Return].

If you did not purchase CCR or NSE, go to step 25.

If you did not purchase CCR but you have enabled NSE, go to step 21. For more information about Ethernet connections, refer to ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR interface cabling.Ó

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide