Meridian America Link/Customer Controlled Routing manual Module address prompt

408Chapter 14: Software installation, upgrade, and update procedures

Procedure 3: Load application software from tape (continued)

Figure 134

Module name prompt

ADD MODULE NAME AND ADDRESS TO TCPIP TRANSPORT PROVIDER DATABASE

If you are not sure how to answer any prompt, type Ò?Ó for HELP.

Your moduleÕs system is currently the default name. We recommend that you change it to avoid possible name conflicts.

Enter the MODULE NAME to be added to the tcpip transport provider database (?, or module name):

16You are prompted for the name of the Application Module or IPE Module (Figure 134). (The term Òmodule nameÓ refers to an Ethernet host computer, which in this case is the Application Module or IPE Module.) Type the module name and press [Return]. The module name must not exceed eight alphanumeric characters. For more information about module names, consult your network administrator.

Figure 135

Module address prompt

Enter the MODULE ADDRESS to be added to the tcpip transport provider database (?, or module address):

17You are prompted for the address of the Application Module or IPE Module (Figure 135). Type the module address and press [Return]. The module address must be four numbers separated by periods, such as Ò12.234.67.89Ó. For more information about module addresses, consult your network administrator.

Figure 136

Reenter prompt

If you made any mistakes in entering the module name and IP address, you can correct them. Would you like to re-enter the module name or IP address? [y,n]:

553-3202-210 Standard October 1998