Meridian America Link/Customer Controlled Routing manual Verify installation prompt

426Chapter 14: Software installation, upgrade, and update procedures

Procedure 5: Load the operating system tape on an Application Module with an MVME147 card (continued)

29You are prompted to indicate whether you wish to install online problem descriptions. Nortel does not use these descriptions. Type n and press [Return] to indicate no.

Figure 168

Verify installation prompt

--->Do you want to verify correct installation? (y, n, q) [y]:

30You are prompted to verify correct installation. Press [Return] to indicate yes.

Confirmation of your selection appears, along with a summary of the installation information. The summary should look exactly as in Figure 169, with the possible exception of the disk drive entry (Ôm147fuj2614Õ).

Figure 169

Software installation summary

Selected to run mkcomply to verify correct installation.

Check the information below. If any part of the information is incorrect, the previous questions will have to be answered again.

*Format and install the new bootloader on the MVME147, controller #0, disk drive #00,

using the ddefs(1M) description Ôm147fuj2614Õ.

*Create a root file system using 1 Kbyte logical blocks

on slice 0 on the MVME147, controller #0, disk drive #00.

*Create a swap area in slice 1 on the MVME147, controller #0, disk drive #00.

*Create a usr file system using 1 Kbyte logical blocks

on slice 2 on the MVME147, controller #0, disk drive #00.

*Install On-line Manual Pages Object Package (OLMP).

*Do Not Install On-line Problem Descriptions (Tars on Tape)

---> Is all of this information correct (y, n, q, ?):

31If the summary information is correct, type y and press [Return]. If it is not correct, type n, press [Return], and then enter the information correctly when prompted.

When the information is correct and you reply y to the above prompt, phases 3 and 4 of the installation begin.

553-3202-210 Standard October 1998