Meridian America Link/Customer Controlled Routing manual

Chapter 15: Link configuration 489

Procedure 14: Changing Meridian Link (link 1) parameters (Meridian Link only)

Meridian Link is shipped with a default configuration for the Host Link. To make changes to the configuration file, use this procedure. Note that you cannot change the values for some parameters. X.25 and LAPB parameters are detailed in Table 142, TCP/IP parameters in Table 143.

!

CAUTION

Risk of potential data loss

Do not use the change link command without the direction of Nortel support personnel or host computer support personnel.

1Log in as mlusr. The default password is mlusr.

2At the Òmlusr>Ó prompt, type display link 1 and press [Return] to see the current configuration for the link to the host computer.

The default link configuration is displayed, as shown under the ÒDefault configurationÓ section earlier in this chapter.

3Type change link 1 and press [Return] to begin making changes.

The first parameter appears, along with the current value.

4Either type a new value for the parameter and press [Return] or just press [Return] to leave the current value unchanged.

Refer to Table 142 or Table 143 for information on link parameters.

5Continue changing parameters until the ÒConfirm (yes or no)Ó prompt appears.

6To confirm the changes, type yes and press [Return]. If you made a mistake and wish to redo your changes, type no, press [Return], and restart this procedure from step 3.

At this point, the changes you have made are saved in memory, but not on disk (if the system is restarted, the changes are lost).

7To save your changes, go to the appropriate procedure:

¥Procedure 16: Replacing the default configuration file

¥Procedure 17: Creating a configuration file

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide