Meridian America Link/Customer Controlled Routing manual

Chapter 15: Link configuration 497

Procedure 15: Changing Meridian Mail Link (link 2) parameters (Meridian Link only)

Meridian Link is shipped with a default configuration for the Meridian Mail Link. If the default configuration is not appropriate, you can use this procedure to change it. Note that you cannot change the values for the protocol and link type parameters. For more information, refer to Table 144 at the end of this procedure.

!

CAUTION

Risk of potential data loss

Do not use the change link command without the direction of Nortel support personnel or host computer support personnel.

1Log in as mlusr (if you are not already logged in). The default password is mlusr.

2At the Òmlusr>Ó prompt, type display link 2 and press [Return] to see the current configuration for the link to the host computer.

The default link configuration is displayed, as shown in Table 144.

3Type change link 2 and press [Return] to begin making changes to the link.

The first parameter appears, along with possible and current values.

4Either type a new value for the parameter and press [Return] or just press [Return] to leave the current value unchanged.

Refer to Table 144 for information on link parameters for the MML.

5Continue changing parameters until the ÒConfirm (yes or no)Ó prompt appears.

6To confirm the changes, type yes and press [Return].

If you made a mistake and wish to redo your changes, type no, press [Return], and restart this procedure from step 3.

At this point, the changes you have made are temporary.

They are saved in memory, but not on disk (which means that if the system is restarted, the changes are lost).

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide