Meridian America Link/Customer Controlled Routing manual Risk of personal injury

Chapter 8: Hardware installation procedures 129

Checking the card option settings (Application Module)

The cards are shipped with the settings preset at the factory, and they need to be checked only if you suspect a problem, or if you need to configure the host computer port (on the MVME705B card) for DTE operation. If you want to check the settings during installation, do so before installing the Application Module.

The following procedure for checking the transition card option settings is one of a series of procedures you perform to install an Application Module. The series is shown in Table 12 in Chapter 5, ÒHardware installation overview.Ó

To check the option settings on the MVME712A, MVME712AM, MVME712M, and MVME705B transition cards, you must remove the cards from the rear of the Application Module. If the Application Module is installed on the right side of the AEM (when viewed from the front of the AEM), it must temporarily be removed to access the transition cards. You do not need to remove the cards in the front of the Application Module to remove the module.

Note: If the Application Module is installed on the left side of the AEM (facing the AEM), you can check the transition cards without removing the Application Module.

!

CAUTION

Risk of personal injury

Be careful when installing an Application Module because it is heavy. This is usually a two-person job.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide