Meridian America Link/Customer Controlled Routing manual To update CCR Release 3B to Release 3C

Chapter 14: Software installation, upgrade, and update procedures 385

Section 12: To update CCR Release 3B to Release 3C

When you update CCR from Release 3B to Release 3C, the release or issue of the BOS changes.

¥Perform Procedure 2: Start the update process.

¥Depending on the type of SBC card installed, perform one of the following:

ÑProcedure 5: Load the operating system tape on an Application Module with an MVME147 card

ÑProcedure 6: Load the operating system tape on an IPE Module or an Application Module with an MVME167 card

¥Perform Procedure 7: Reboot and go through setup.

¥Perform Procedure 8: Load the application software from tape.

¥Perform Procedure 9: Restore configuration files and data files from the backup tape to customize your system.

¥Perform Procedure 10: Verify the installation to confirm that the installation is complete and correct.

¥Perform Procedure 11: Back up configuration files and data files to back up the customized new release.

Section 13: To update CCR from Release 3B to Co-residency

If you already have CCR Release 3B and want to update to co-residency, you just enter a new keycode to activate CCR and Meridian Link.

To do this, perform Procedure 1: Application configuration and start-up.

Section 14: To update Co-residency from one issue to another issue of the same release

When you update Co-residency from one issue of a release to another issue of the same release (for example, from issue 6.2 to issue 6.4), one of the following circumstances applies:

¥The release or issue of the BOS changes

¥The release or issue of the BOS does not change

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide