Chapter 15: Link configuration 485

Procedure 13: Changing AML (link 0) parameters (continued)

3Type change link 0 and press [Return] to begin making changes to the link.

The first parameter appears, along with possible and current values.

Note: All the fields displayed in Figure 260 except for ÒLink typeÓ and ÒPort typeÓ may be changed by executing the Òchange link xÓ command.

Figure 260

Change link parameters

Machine ID

Current SL16

>

4To change the parameter, type the new value and press [Return]. To leave the parameter unchanged, just press [Return].

Refer to Table 141 for information on link parameters.

5Continue with remaining parameters until the ÒConfirm (yes or no)Ó prompt appears.

6To confirm the changes, type yes and press [Return].

If you made a mistake and wish to redo your changes, type no, press [Return], and restart this procedure from step 3.

At this point, the changes you have made are temporary. They are saved in memory, but not on disk (which means that if the system is restarted, the changes are lost).

7To save your changes, go to the appropriate procedure:

¥Procedure 16: Replacing the default configuration file

¥Procedure 17: Creating a configuration file

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide

Page 503
Image 503
Meridian America Link/Customer Controlled Routing Procedure 13 Changing AML link 0 parameters, Change link parameters