Meridian America Link/Customer Controlled Routing manual Seagate

436Chapter 14: Software installation, upgrade, and update procedures

Procedure 6: Load the operating system tape on an IPE Module or an Application Module with an MVME167 card (continued)

Figure 183

Continue start-up prompt

Continue System Start Up (Y/N)?

13You are prompted to continue start-up. Type y and press [Return].

Note: It is normal for the Fail indicator on the SBC card to flash while diagnostics are being run (after power-on or during rebooting).

A series of test messages will appear on one line across the screen for approximately ten minutes. The system start-up messages begin to appear as shown in the following figure.

Figure 184

System start-up messages

Testing Complete

Autoboot in progress ... To abort hit <BREAK>

Booting from: VME167, Controller 0, Drive 40

Loading: Operating System

Volume: V/68

IPL loaded at: $001F0000

MVMETAPE IPL Version 1.0

***********************************************************************

System V/68 Release R3V7 M68040 Version 920526

Real mem = 6291456

Avail mem = 4956160

Buffers = 60

***********************************************************************

Copyright (c) 1984-1992 Motorola Inc. All rights reserved

INIT: SINGLE USER MODE
***
erase = #	kill = @		intr = DEL quit		= ^
***
167 SCSI configuration
Device	Addr Vers Revision			Serial#	Blocks	Size Vendor Description
-------	---- ---- --------			-------	-------	---- -------------------
Disk	00	0002	9324		0478845	0512	SEAGATE	ST3283N
Tape	40	0001	RV F		0000000	0000	TEAC	MT-2ST/N50

Enter the correct date and time EST using one of the following formats [mmddhhmmyy] or [mmddhhmmyyyy]:

553-3202-210 Standard October 1998