Meridian America Link/Customer Controlled Routing manual Reenter prompt, Reboot prompt

Chapter 14: Software installation, upgrade, and update procedures 395

Procedure 1: Application configuration and start-up (continued)

Figure 111

Module address prompt

Enter the MODULE ADDRESS to be added to the tcpip transport provider database (?, or module address):

19You are prompted for the address of the Application Module or IPE Module (Figure 142). Type the module address and press [Return]. The module address must be four numbers separated by periods, such as Ò12.234.67.89Ó. For more information about module addresses, consult your network administrator.

Figure 112

Reenter prompt

If you made any mistakes in entering the module name and IP address, you can correct them. Would you like to re-enter the module name or IP address? [y,n]:

20You are asked whether you want to reenter the module name or address (Figure 112).

If you have not made a mistake, type n and press [Return]. Go to step 21.

If you want to reenter the module name and address, type y and press [Return]; you will return to step 18.

Figure 113

Reboot prompt

Entry for <module name> with address <address> added to tcpip transport provider database.

Now your system has been modified. You must reboot the system to have the new kernel take effect.

Would you like to reboot the system now (y/n) ?

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide