Meridian America Link/Customer Controlled Routing manual Input/output cables, Internal I/O cables

Models: Link/Customer Controlled Routing

1 595
Download 595 pages 8.52 Kb
Page 237
Image 237

Chapter 9: Meridian Link/CCR interface cabling 219

Input/output cables

The Application Module has two types of I/O cable. These include

¥internal cables that connect circuit cards to disk and tape drives within the Application Module

¥external cables that connect the Application Module to the Meridian 1, the system console, and application terminals (if applicable)

Internal I/O cables

Internal cables interconnect components that are not connected through the VME bus backplane. Table 77 lists the Application Module internal cables. Figure 58 shows the internal cabling scheme.

Table 77

Internal I/O cables (Application Module)

Part number

Cable description and application

 

 

NT7D52AA

Power monitor cableÑ3-pin connector, yellow and gray twisted wire cable:

(A0372656)

carries signals from the power sense card (P1) to the power monitor (P1 for

 

a left-hand Application Module, P2 for a right-hand Application Module)

 

 

NT7D53AA

SCSI cableÑ50-pin connector cable: carries the SCSI interface from the

(A0372657)

floating connectors (J3) to the disk/tape drives (J1)

 

 

NT7D56AC

SCSI extension cableÑ50-pin connector cable: carries the SCSI interface

(A0404311)

from the adapter board (J3) to the external SCSI I/O port (via the

 

MVME712M card) and the disk/tape unit (P3)

 

 

NT7D57AA

J2 output cableÑ64-pin connector, flat ribbon cable: carries I/O from the

(A0372913)

MVME333-2 XCC card to the MVME705B transition card, from the P2

 

adapter board (J2) to the MVME712M transition card (J2), and from the

 

MVME332XTS ACC card to the NT6D51AA transition card

 

 

NT7D76AA

Adapter board to transition card cableÑ64-pin connector, flat ribbon cable:

(MVME712A/AM

carries I/O from the adapter board (J2) to the MVME712 transition card

only)

(J11)

 

 

NT8D46AA

System monitor cableÑ40-pin connector cable: carries signals from the

(A0356972)

power monitor (J1, J2) to the system monitor in the column

 

 

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide

Page 237
Image 237
Meridian America Link/Customer Controlled Routing manual Input/output cables, Internal I/O cables