Meridian America Link/Customer Controlled Routing manual Risk of hardware damage

208Chapter 9: Meridian Link/CCR interface cabling

NT8D37 backplane cable rerouting for segment 3Ñto accommodate the IPE Module in PE slots 12Ð15

With the cables located as shown in Table 67:

1Leave cable R as is in slot position L12.

2Remove cable T from the backplane and connect cable ends T-1, T-2, and T-3 to slot positions L15-1, L15-2, and L15-3.

3Move the T connector on the I/O panel to position U. Now the cable designation is changed from T to U.

!

CAUTION

Risk of hardware damage

With this cable rerouting, the IPE Module can be used only in PE slots 12Ð15. Also, when the IPE Module is not in PE slots 12Ð15, PE slot 14 should not be used at all.

Note: Reroute the cable only in the segment where the IPE Module is going to be installed. Do not reroute the cable in other segments.

553-3202-210 Standard October 1998