Meridian America Link/Customer Controlled Routing manual Start-up interrupt menu appears

Chapter 14: Software installation, upgrade, and update procedures 429

Procedure 6: Load the operating system tape on an IPE Module or an Application Module with an MVME167 card

If you have just installed a new MVME167 card in an Application Module and you are installing the software for the first time, you need to do steps 2Ð6. Otherwise, skip these five steps.

Note: If you intend to activate CCR and use terminals or printers, ensure that the MVME332XT or MVME332XTS card is installed before you start this procedure.

This procedure assumes that you have backed up all files and have powered down the IPE Module or the Application Module (Procedure 4).

1Turn on the power. If the Ò167-Diag>Ó or the Ò167-Bug>Ó prompt appears, go to step 5. If the Ò4120-Diag>Ó or the Ò4120-Bug>Ó prompt appears, go to step 4. If the following messages appear on the console, go to step 2.

Figure 172

System restart messages (IPE Module or MVME167 card)

Copyright Motorola Inc. 1988 - 1992, All Rights Reserved

VME167 Debugger/Diagnostics Release Version 1.4 - 07/22/92

COLD Start

Local Memory Found = 00800000 (&8388608)

MPU Clock Speed = 25Mhz

2Type h as soon as messages start to appear. If you are too late, press either the [F5] or the [Break] key.

The start-up interrupt menu appears.

3If you are using an IPE Module, go to step 4.

If you are using a new MVME167 card, go to step 5.

If you are using a previously configured MVME167 card, go to step 7.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide