Meridian America Link/Customer Controlled Routing manual

Chapter 12: Meridian 1 configuration for Meridian Link/CCR 317

Configure SDI port for conshare (X11 Release 18 or later)

The SDI port is used for the optional console sharing feature, which allows the IPE Module or the Application Module console to access Meridian 1 administration and maintenance programs. Port settings on the card should reflect TTY mode at 2400 baud. Define the SDI port and its characteristics by responding to the following prompts in LD 17.

Table 112

LD 17ÑConfigure SDI port (X11 Release 18 or later)

Prompt	Response	Comment
REQ	CHG	Create or change information in the database
TYPE	CFN	Configuration record data block
ADAN	NEW TTY x	Add SDI on port x (0Ð15) for console sharing
CTYP	SDI	Single port SDI card
	SDI2	Dual port SDI card
	SDI4	Four port SDI card
	XSDI	SDI Paddle Board
DNUM	0Ð15	Device number (same as ADAN number)
USER	aaa aaa	Enter one or more of the following terminal
		functions:
	CDR	CDR data link
	BUG	BUG error messages on this port
	CSC	Automatic Set Relocation and Attendant
		Administration messages
	CTY	CDR TTY port
	MTC	Allow maintenance overlays
	NOO	No overlay allowed
	SCH	Allow service change overlays
	TRF	Traffic reports
XSM	YES, (NO)	SDI port for the System Monitor
ADAN	<cr>	Go to next prompt

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide