Meridian America Link/Customer Controlled Routing manual Save link parameters

Chapter 15: Link configuration 499

Procedure 16: Replacing the default configuration file

Meridian Link and CCR are shipped with a default link configuration. The default configuration is shipped in the following file or files:

¥AML (link 0): /usr/mlusr/conf/hdlcmlnk.datafile

¥Host Link (link 1): /usr/mlusr/conf/x25hlnk.datafile (Meridian Link only)

¥MML (link 2): /usr/mlusr/conf/vlink.datafile (Meridian Link only)

If you have changed the default parameters in Procedure 13, 14, or 15, you can do one of the following:

¥Use this procedure to replace the default configuration with the changed configuration.

¥Use Procedure 17 to store the changed configuration in another file.

1Use Procedure 13, 14, or 15 to change the configuration parameters.

2At the Òmlusr>Ó prompt, type save link x (where x is the link number) and press [Return].

The following messages appear, in which ÒfilenameÓ represents the name of the default configuration file.

Figure 261

Save link parameters

File "filename" already exists. OK to overwrite?

Confirm? (yes or no):

3Type yes and press [Return] to confirm that you wish to overwrite the file.

Your changes have now been saved on the hard disk.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide