Meridian America Link/Customer Controlled Routing manual Tape prompt, Meridian 1 ID prompt

388Chapter 14: Software installation, upgrade, and update procedures

Procedure 1: Application configuration and start-up

1Set the Application Module circuit breaker or the IPE Module power pushbutton to ON (if it is not already on).

Wait for the system to boot UNIX from the hard disk. If the ÒConsole Login:Ó prompt does not appear, refer to the Application Module and Intelligent Peripheral Equipment Module Diagnostic and Maintenance Guide (NTP 553-3211-510).

2Type maint and press [Return] at the ÒConsole Login:Ó prompt to log in as the maintenance user.

3You are prompted to enter a password. Type the password for the maint account and press [Return]. The password for maint is maint.

4At the Òmaint>Ó prompt, type install and press [Return].

Figure 96

Tape prompt

You can reconfigure the system using a keycode without a tape or you can use a tape to upgrade the software and reconfigure. Do you want to use a tape (y/n/q)?

5You are prompted to use a tape (Figure 96). Type n and press [Return].

Figure 97

Meridian 1 ID prompt

Please enter the Meridian 1 ID of this site (or Q or q to quit):

6You are prompted to enter your Meridian 1 ID (Figure 97). Type your ID and press [Return].

553-3202-210 Standard October 1998