Meridian America Link/Customer Controlled Routing manual

Chapter 14: Software installation, upgrade, and update procedures 393

Procedure 1: Application configuration and start-up (continued)

Figure 108

Ethernet connection prompt

Installing NSE R3V7.1. Please wait.

Is your module connected to the Ethernet (y/n) ?

17You are asked whether your Application Module or IPE Module is connected to Ethernet (Figure 108).

For more information about Ethernet connections, refer to Chapter 9, ÒMeridian Link/CCR interface cablingÓ.

If your module is not connected to Ethernet, type n and press [Return]. Go to step 21.

If you are connected to Ethernet and you plan to use it in the near future, type y and press [Return]. You see a message asking you to wait. Then you see more installation messages (Figure 109). Go to step 18.

If you are connected to Ethernet but do not plan to use it in the near future, you may choose to type n and press [Return]. Disabling Ethernet support increases the processing power available to your application(s). Go to step 21.

ATTENTION

If you disable Ethernet support, you must perform a complete reinstallation of the base operating system and application(s) before you can reenable Ethernet support.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide