Meridian America Link/Customer Controlled Routing Method, IPE Module Option 11 connections Part

170Chapter 9: Meridian Link/CCR interface cabling

Figure 43

IPE Module Option 11 connections (Part 1)

Meridian 1 Option 11

			Method 1
	Internal
NTAK01	bus
CPU/Conf			A0368901
		SDI
port 0
			Note 4

					IPE
					Module
						Connector
1						Panel
3
	NT1R03AA		NT1R03CA
5
	(octopus		(extension
7
		cable)		cable)

NTAK03

TDS/DTR (Note 3)

port 0

port 1

J1 (Note 1)	Method 2
Internal		Note 4
bus
	NTAK19AA
	(2-port
	cable)

				IPE
				Module
					Connector
1					Panel
3
	NT1R03AA	NT1R03CA
5
7	(octopus	(extension
	cable)		cable)

Note 1: It is recommended that the TDS/DTR card be installed in position 1. The SDI/DCH card may be

installed in any other position except position 0 (for the CPU/Conf card).

Note 2: Refer to the Meridian 1 Option 11 Installation Guide (NTP 553-3011-210) for cross connections.

Note 3: The NTAK03 TDS/DTR card is not available for Option 11E.

Note 4: Use an NT1R03D extension cable if you need additional length.

553-3202-210 Standard October 1998