Meridian America Link/Customer Controlled Routing manual CCR customer number prompt

406Chapter 14: Software installation, upgrade, and update procedures

Procedure 3: Load application software from tape (continued)

If you did not purchase CCR but you have enabled NSE, go to step

16.For more information about Ethernet connections, refer to ÒInstalling Ethernet LAN supportÓ in the ÒMeridian Link/CCR interface cabling.Ó

If you have purchased CCR, go to step 14.

Figure 131

CCR customer number prompt

Please enter the CCR customer number (0-99):

14You are prompted to enter your customer number (Figure 131). Type the customer number and press [Return].

Note: A two-minute pause occurs at this point before the following messages appear.

Figure 132

Ethernet connection prompt

Installing NSE R3V7.1. Please wait.

Is your module connected to the Ethernet (y/n) ?

15You are asked whether your Application Module or IPE Module is connected to Ethernet (Figure 132).

For more information about Ethernet connections, refer to Chapter 9, ÒMeridian Link/CCR interface cabling.Ó

If your module is not connected to Ethernet, type n and press [Return]. Go to step 19.

If you are connected to Ethernet and you plan to use it in the near future, type y and press [Return]. You see a message asking you to wait. Then you see more installation messages (Figure 133). Go to step 16.

553-3202-210 Standard October 1998