Meridian America Link/Customer Controlled Routing Default DCE/DTE settings Port Setting Use, Dte

Chapter 8: Hardware installation procedures 121

Table 28

Default DCE/DTE settings

Port	Setting	Use
1	DCE	Console
2	DCE	Modem
3	DTE	Conshare
4	DTE	Meridian Mail Link
5	DTE	AML
6	DCE	Terminal/printer (CCR)
		X.25 Host Link (Meridian Link)
7	DCE	Terminal/printer
8	DCE	Terminal/printer

Refer to Figure 30 (Part 2) for a diagram of the correct jumper settings. To change the configuration of a port after you have installed an IPE Module, you must remove the IPE Module from the Meridian 1 IPE Shelf or Option 11 cabinet. For more information on DCE and DTE, refer to Chapter 11, ÒPeripheral device cabling interface.Ó

!

CAUTION

Risk of data loss

Do not install the IPE Module if the IPE Module power push button is in the On position.

2Choose where you want to install the IPE Module. An Option 11 IPE Module occupies three consecutive slots in an Option 11 cabinet. An Options 21Ð81 IPE Module occupies four consecutive slots on an IPE shelf. For more information, refer to Chapter 4, ÒMeridian Link/CCR hardware.Ó

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide