Meridian America Link/Customer Controlled Routing manual

Chapter 11: Peripheral device cabling interface 283

Configuring the UDS 2440 modem for remote diagnostics

There are two ways to configure the UDS 2440 modem for remote diagnostics: one procedure uses the modemÕs front panel buttons, while the alternative procedure allows for configuration via a workstation. Both procedures are outlined below.

The following procedure explains how to configure the UDS 2440 modem via the front panel buttons on the modem.

1Connect the modem to a power source next to the system.

2Position the power switch on the rear panel of the modem to ON.

The LCD on the front panel will display the following: ####-##(for example, 3050-5C, appears for two seconds).

3Answer the prompts by pressing either the YES or the NO button on the front of the modem panel. Each response will appear in the LCD window. Table 103 lists the prompts and responses.

Note: If you press the wrong button, press the TALK/DATA button followed by the NO button. This returns you to step 2.

Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide