Meridian America Link/Customer Controlled Routing manual CCR customer number prompt

392Chapter 14: Software installation, upgrade, and update procedures

Procedure 1: Application configuration and start-up (continued)

The system lists the application or applications installed.

Note: Figure 106 only shows applications that have been selected; they are actually enabled when the system reboots at the end of this procedure.

15The system prompts you to verify that the list is correct.

To check that the correct application has, or applications have, been activated, refer to the checklist (Table 17) you completed in the ÒIPE Module and Application Module: Meridian Link/CCR softwareÓ section in Chapter 6, ÒSite survey/installation checklist.Ó

If the list is incorrect, type n and press [Return]. You are returned to step 6. Rekey your Meridian ID and keycode. If the list of applications is still incorrect, type q and press [Return]. The message ÒSoftware not configuredÓ appears. Call your Nortel support personnel for a new keycode.

If the list is correct, type y and press [Return].

If you did not purchase CCR or NSE, go to step 21.

If you did not purchase CCR but you have enabled NSE, go to step

17.For more information about Ethernet connections, refer to ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR interface cabling.Ó

If you have purchased CCR, go to step 16.

Figure 107

CCR customer number prompt

Please enter the CCR customer number (0-99):

16You are prompted to enter your CCR customer number (Figure 138). Type the number and press [Return].

Note: A two-minute pause occurs at this point before the following messages appear.

553-3202-210 Standard October 1998