Nortel Networks MOG7xx, MOG6xx Mounting the WLAN IP Telephony Manager, Pre-installation checklist

42

•Screws – used to mount the WLAN IP Telephony Manager 2245 to the wall. Four 3/4-inch #8 panhead wood screws (or similar devices) are required.

•CAT5 cable with an RJ-45 connector for the WLAN IP Telephony Manager 2245 – provides a connection to the Ethernet switch.

•DB-9 female null-modem cable – required for initial configuration of the WLAN IP Telephony Manager 2245.

Note: The WLAN IP Telephony Manager 2245 requires a maximum distance of 325 feet (100 meters) from the Ethernet switch.

Pre-installation checklist

Ensure that the following requirements have been met prior to installation:

•The location is adequate and power is available.

•Access Points (APs) are SVP-compatible and coverage is adequate.

•A dedicated line is available for remote modem access, if needed.

•The telephone system administrator is on-site to program the existing telephone system.

Mounting the WLAN IP Telephony Manager 2245

The WLAN IP Telephony Manager 2245 can be mounted either vertically or horizontally.

The rack-mount kit is designed for mounting the WLAN IP Telephony Manager 2245 in a standard 19-inch rack and contains the following equipment:

•Mounting plates – two for each WLAN IP Telephony Manager 2245 to be mounted.

•Screws – four rack-mount screws for each WLAN IP Telephony Manager 2245 to be mounted.

Wall-mounting the WLAN IP Telephony Manager 2245

1Use a 1/8-inch drill bit to drill four pilot holes, on 1.84-inch by 12.1-inch centers (approximately equivalent to 1 13/16-inch by 12 1/8-inch).

2Insert the 3/4-inch #8 screws in the pilot holes and tighten, leaving a 1/8-inch to 1/4-inch gap from the wall.

3Slide the WLAN IP Telephony Manager 2245 over the screws until the WLAN IP Telephony Manager 2245 drops into place in the keyhole openings of the flange.

4Tighten screws fully.

WLAN IP Telephony Manager 2245 installation