.
27
DC power supply installation
This chapter provides instructions to install the DC power supply in the Ethernet Routing Switch 8300 chassis.
See Nortel Ethernet Routing Switch 8300 Administration,
ATTENTION
Nortel recommends that you install each power supply on its own dedicated branch circuit to ensure that a fault on another branch circuit does not cascade to other branch circuits.
Prerequisites
•Verify that you have the following tools and materials:
—cable
—crimping tool for crimping the lugs onto the cable
—heat gun to shrink the tubing around the cable (optional)
—
—Phillips screwdriver
•Determine the minimum number of DC power supplies to be installed. For more information, see “Determining the minimum number of DC power supplies” (page 28)
DC power supply installation procedures
This task flow shows you the sequence of procedures you perform to install the duel input DC power supply in the Ethernet Routing Switch 8300. To link to any tasks, go to “DC power supply installation navigation” (page 28).
Nortel Ethernet Routing Switch 8300
Installation — DC Power Supply
9 June 2008
Copyright © 2008 Nortel Networks
