Step Four Attach wheels to cart base | North Star MTBSL instruction

Assembly (continued)

Step Four: Attach wheels to cart base

1.Slide axle into holes on bottom of cart base.

2.Slide the tires and wheel retainers onto the axle.

3.Tighten wheel retainers down with supplied hex wrench.

Cart base

Axle

Wood plank or spacer (Not included)

Wheel retainer

Tire

Step Five: Attach boom supports and boom bracket to cart base

1.Fasten the boom supports to the cart base with (4) 5/16 x ¾” carriage bolts and (4) 5/16 flange nuts. Tighten to 20 ft-lbs.

2.Fasten the boom bracket to the boom supports with (4) 5/16 x ¾” carriage bolts and (4) 5/16 flange nuts. Tighten to 20 ft-lbs.

5/16 Flange nut

Boom support

Cart base

			Boom bracket
		Boom support	5/16 x ¾”
	5/16 x ¾” Carriage bolt		5/16 x ¾”
	5/16 x ¾” Carriage bolt	5/16 Flange nut	Carriage bolt
		5/16 Flange nut	Carriage bolt

11

Image 11

North Star MTBSL Step Four Attach wheels to cart base, Step Five Attach boom supports and boom bracket to cart base

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended Use Chemical Application Safety Summary of Important Safety InformationDuring Assembly General Chemical Safety Towing Safety Chemical accident procedures Differently with filled sprayer attached Unpacking Closely inspect all contents in the shipping carton Following items are found in the manual bag Unpacking the Manual Bag Step Three Attach the cart base to the sprayer AssemblyStep One Attach the tongue to the cart base Step Two Attach the hitch mount to the tongue Step Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart base Step Six Attach boom arms to the boom bracket Step Ten Attach drain cap to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Nine Attach gun clips to tank Step Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pump Step Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle battery Connected to the battery Working condition Step Fifteen Check and test completed assemblyCheck and test completed assembly Check assembly Machine Components General Chemical Safety Operation Important Safety Information After Spraying Chemical Application SafetyBefore Spraying During Spraying Towing Safety Inhalation Inspect Inspect and test the sprayer thoroughly Repair Important safety rulesOperation Preparing the Sprayer for Each Use Spray because the wind is too strong Operation Using the SprayerStep One Assess wind conditions and clear work area Ensure tank is flushed of all chemicals from prior uses Fill the sprayer using the following stepsStep Two Fill the sprayer Fill tank Check drain Begin agitation if Review safetyStep Three Operate the sprayer Unfold one or both boom arms as required Adjust nozzleSqueeze trigger & To spray, squeeze the gun trigger Ensure uniform coverage Ensure correct spray pattern Launder Step Four Clean sprayer and decontaminate after useDrain tank Decontaminate Add antifreeze StoragePreparing for storage Removing from storage Before attempting to service the sprayer Troubleshooting Any Questions, Comments, Problems or Parts Orders Specifications Part# Description Model Qty Exploded View 28517/28518 Rev. L Height Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Spray Pressure