Manuals / North Star / Lawn and Garden / Pest Control Equipment

North Star MTBSL owner manual Assembly, Step One Attach the tongue to the cart base

Models: MTBSL

1 35

Download 35 pages 13.1 Kb

Page 10

Assembly

Step One: Attach the tongue to the cart base

Fasten with (2) 5/16 x ¾” carriage bolts and (2) 5/16 flange nuts. Tighten to 20 ft-lbs.

Step Two: Attach the hitch mount to the tongue

Fasten with (2) 5/16 x ¾” carriage bolts and (2) 5/16 flange nuts. Tighten to 20 ft-lbs.

5/16 x ¾” Carriage bolt

Cart base

Hitch

5/16 Flange nut Tongue

5/16 Flange nut

Step Three: Attach the cart base to the sprayer

Note: To protect the pump from damage, place two wood planks or spacers under the sprayer to keep the pump from resting on the ground.

Using (4) 5/16 flat washers, loosely thread (4) 5/16 x ½” flange bolts into the inserts in the bottom of the sprayer. Center the sprayer on the cart base and tighten to 10 ft-lbs.

Cart base

Sprayer

5/16 x ½” Flange bolt

5/16 Flat washer

Wood planks or spacers (Not included)

10

Image 10

North Star MTBSL Assembly, Step One Attach the tongue to the cart base, Step Two Attach the hitch mount to the tongue

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Intended Use Spraying PesticidesGeneral Chemical Safety Summary of Important Safety InformationDuring Assembly Chemical Application SafetyChemical accident procedures Towing SafetyDifferently with filled sprayer attached Closely inspect all contents in the shipping carton UnpackingUnpacking the Manual Bag Following items are found in the manual bagStep Two Attach the hitch mount to the tongue AssemblyStep One Attach the tongue to the cart base Step Three Attach the cart base to the sprayerStep Four Attach wheels to cart base Step Five Attach boom supports and boom bracket to cart baseStep Six Attach boom arms to the boom bracket Step Nine Attach gun clips to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Ten Attach drain cap to tankStep Eleven Install boom valve to pump Step Twelve Connect boom valve to boom nozzlesStep Fourteen Connect remote switch to vehicle battery Step Thirteen Attach sprayer to vehicleConnected to the battery Check assembly Step Fifteen Check and test completed assemblyCheck and test completed assembly Working conditionMachine Components Operation Important Safety Information General Chemical SafetyDuring Spraying Chemical Application SafetyBefore Spraying After SprayingTowing Safety Inhalation Operation Preparing the Sprayer for Each Use Important safety rulesInspect Inspect and test the sprayer thoroughly Repair Step One Assess wind conditions and clear work area Operation Using the SprayerSpray because the wind is too strong Step Two Fill the sprayer Fill the sprayer using the following stepsEnsure tank is flushed of all chemicals from prior uses Check drain Fill tankStep Three Operate the sprayer Review safetyBegin agitation if Squeeze trigger & To spray, squeeze the gun trigger Adjust nozzleUnfold one or both boom arms as required Ensure correct spray pattern Ensure uniform coverageDecontaminate Step Four Clean sprayer and decontaminate after useDrain tank LaunderRemoving from storage StoragePreparing for storage Add antifreezeTroubleshooting Before attempting to service the sprayerSpecifications Any Questions, Comments, Problems or Parts OrdersExploded View 28517/28518 Rev. L Part# Description Model QtySpray Pressure Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Height