Step Seven Attach gun hose to spray gun and pump | North Star MTBSL

Gun hose Hose clamp

Pump hose barb

Assembly (continued)

Step Seven: Attach gun hose to spray gun and pump

1.Attach one end of gun hose to the pump hose barb. Follow hose clamp installation instructions.

2.Attach the other end of gun hose to the spray gun. Follow hose clamp installation instructions.

Step Eight: Attach hose guide to tank

Route gun hose around sprayer and through hose guide, then attach hose guide to tank with (1)

5/16 x ½” flange bolt.

Hose clamp installation instructions 1. Slide hose clamp over the end of

the hose

2. Push the hose onto the hose barb

3. Slide the hose clamp over the hose barb

4. Tighten the hose clamp

5/16 x ½” Flange bolt

Hose guide

Spray gun

Hose clamp

Step Nine: Attach gun clips to tank

Fasten the gun clips to the sprayer tank with (2) #10 x ¼” screws.

Step Ten: Attach drain cap to tank

Press the rubber washer into the drain cap, then thread the drain cap onto the tank.

#10 x ¼” screw

Gun clip

Rubber washer

Drain cap

13

Image 13

North Star MTBSL owner manual Step Seven Attach gun hose to spray gun and pump, Step Eight Attach hose guide to tank

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended Use During Assembly Summary of Important Safety InformationGeneral Chemical Safety Chemical Application Safety Towing Safety Chemical accident procedures Differently with filled sprayer attached Unpacking Closely inspect all contents in the shipping carton Following items are found in the manual bag Unpacking the Manual Bag Step One Attach the tongue to the cart base AssemblyStep Two Attach the hitch mount to the tongue Step Three Attach the cart base to the sprayer Step Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart base Step Six Attach boom arms to the boom bracket Step Eight Attach hose guide to tank Step Seven Attach gun hose to spray gun and pumpStep Nine Attach gun clips to tank Step Ten Attach drain cap to tank Step Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pump Step Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle battery Connected to the battery Check and test completed assembly Step Fifteen Check and test completed assemblyCheck assembly Working condition Machine Components General Chemical Safety Operation Important Safety Information Before Spraying Chemical Application SafetyDuring Spraying After Spraying Towing Safety Inhalation Operation Preparing the Sprayer for Each Use Important safety rulesInspect Inspect and test the sprayer thoroughly Repair Step One Assess wind conditions and clear work area Operation Using the SprayerSpray because the wind is too strong Step Two Fill the sprayer Fill the sprayer using the following stepsEnsure tank is flushed of all chemicals from prior uses Fill tank Check drain Step Three Operate the sprayer Review safetyBegin agitation if Squeeze trigger & To spray, squeeze the gun trigger Adjust nozzleUnfold one or both boom arms as required Ensure uniform coverage Ensure correct spray pattern Drain tank Step Four Clean sprayer and decontaminate after useDecontaminate Launder Preparing for storage StorageRemoving from storage Add antifreeze Before attempting to service the sprayer Troubleshooting Any Questions, Comments, Problems or Parts Orders Specifications Part# Description Model Qty Exploded View 28517/28518 Rev. L Approximate flow from one nozzle Appendix a Broadcast Spray Calibration TablesSpray Pressure Height