Storage, Preparing for storage, Add antifreeze | North Star MTBSL

Storage

Preparethe sprayer for end-of-season storage by running RV antifreeze through the system. This will keep internal parts lubricated, protect against corrosion, and keep the unit from freezing.

CAUTION

The sprayer will be damaged if it freezes.

Protect the sprayer from freezing during storage by following the instructions below.

Preparing for storage:

1. Add antifreeze

Pour 1 gallon of RV antifreeze into the tank.

Note: RV antifreeze is non-toxic and biodegradable and generally safer for the environment than automotive antifreeze.

2. Spray briefly

Turn on the pump motor and squeeze the gun trigger briefly until fluid sprays.

Removing from storage:

1.	Drain	Drain the antifreeze left in the tank through the tank drain hole into a
		suitable container.

2.	Flush with	Fill the tank with fresh water and run through the system. Operate the
	water	spray gun until the system is completely flushed. Be sure to set up
		containers to capturethe antifreeze flush water.

3.	Disposal	Dispose of the antifreeze and flush water properly.

31

Image 31

North Star MTBSL owner manual Storage, Preparing for storage, Removing from storage, Add antifreeze, Spray briefly

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended Use Chemical Application Safety Summary of Important Safety InformationDuring Assembly General Chemical Safety Towing Safety Chemical accident procedures Differently with filled sprayer attached Unpacking Closely inspect all contents in the shipping carton Following items are found in the manual bag Unpacking the Manual Bag Step Three Attach the cart base to the sprayer AssemblyStep One Attach the tongue to the cart base Step Two Attach the hitch mount to the tongue Step Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart base Step Six Attach boom arms to the boom bracket Step Ten Attach drain cap to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Nine Attach gun clips to tank Step Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pump Step Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle battery Connected to the battery Working condition Step Fifteen Check and test completed assemblyCheck and test completed assembly Check assembly Machine Components General Chemical Safety Operation Important Safety Information After Spraying Chemical Application SafetyBefore Spraying During Spraying Towing Safety Inhalation Operation Preparing the Sprayer for Each Use Important safety rulesInspect Inspect and test the sprayer thoroughly Repair Step One Assess wind conditions and clear work area Operation Using the SprayerSpray because the wind is too strong Step Two Fill the sprayer Fill the sprayer using the following stepsEnsure tank is flushed of all chemicals from prior uses Fill tank Check drain Step Three Operate the sprayer Review safetyBegin agitation if Squeeze trigger & To spray, squeeze the gun trigger Adjust nozzleUnfold one or both boom arms as required Ensure uniform coverage Ensure correct spray pattern Launder Step Four Clean sprayer and decontaminate after useDrain tank Decontaminate Add antifreeze StoragePreparing for storage Removing from storage Before attempting to service the sprayer Troubleshooting Any Questions, Comments, Problems or Parts Orders Specifications Part# Description Model Qty Exploded View 28517/28518 Rev. L Height Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Spray Pressure