Step Six Attach boom arms to the boom bracket | North Star MTBSL

Assembly (continued)

Step Six: Attach boom arms to the boom bracket

1.Attach the boom arms to the boom bracket with (2) 5/16 x 1” bolts, (2) 5/16 nyloc nuts, and

(4) 5/16 flat washers.

2.Tighten nuts until the boom arms do not move freely. (They should still be loose enough to move up and down.)

Boom arm

5/16 Flat washer

5/16 Nyloc nut

5/16 Flat washer

5/16 x 1” Bolt

Boom bracket

5/16 Nyloc nut 5/16 Flat washer Boom arm

5/16 Flat washer Boom bracket

5/16 x 1” Bolt

12

Image 12

North Star MTBSL owner manual Step Six Attach boom arms to the boom bracket

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Intended Use Spraying Pesticides Summary of Important Safety Information During AssemblyGeneral Chemical Safety Chemical Application Safety Chemical accident procedures Towing Safety Differently with filled sprayer attached Closely inspect all contents in the shipping carton Unpacking Unpacking the Manual Bag Following items are found in the manual bag Assembly Step One Attach the tongue to the cart baseStep Two Attach the hitch mount to the tongue Step Three Attach the cart base to the sprayer Step Four Attach wheels to cart base Step Five Attach boom supports and boom bracket to cart base Step Six Attach boom arms to the boom bracket Step Seven Attach gun hose to spray gun and pump Step Eight Attach hose guide to tankStep Nine Attach gun clips to tank Step Ten Attach drain cap to tank Step Eleven Install boom valve to pump Step Twelve Connect boom valve to boom nozzles Step Fourteen Connect remote switch to vehicle battery Step Thirteen Attach sprayer to vehicle Connected to the battery Step Fifteen Check and test completed assembly Check and test completed assemblyCheck assembly Working condition Machine Components Operation Important Safety Information General Chemical Safety Chemical Application Safety Before SprayingDuring Spraying After Spraying Towing Safety Inhalation Important safety rules Operation Preparing the Sprayer for Each UseInspect Inspect and test the sprayer thoroughly Repair Operation Using the Sprayer Step One Assess wind conditions and clear work areaSpray because the wind is too strong Fill the sprayer using the following steps Step Two Fill the sprayerEnsure tank is flushed of all chemicals from prior uses Check drain Fill tank Review safety Step Three Operate the sprayerBegin agitation if Adjust nozzle Squeeze trigger & To spray, squeeze the gun triggerUnfold one or both boom arms as required Ensure correct spray pattern Ensure uniform coverage Step Four Clean sprayer and decontaminate after use Drain tankDecontaminate Launder Storage Preparing for storageRemoving from storage Add antifreeze Troubleshooting Before attempting to service the sprayer Specifications Any Questions, Comments, Problems or Parts Orders Exploded View 28517/28518 Rev. L Part# Description Model Qty Appendix a Broadcast Spray Calibration Tables Approximate flow from one nozzleSpray Pressure Height