Step Thirteen Attach sprayer to vehicle

Assembly (continued)

Step Thirteen: Attach sprayer to vehicle

1.Secure the sprayer to the tow vehicle with a hitch pin (not included, call 800.270.0810 and order Item# 2501946).

2.Make sure both boom nozzles are pointed toward the ground. If they are not, loosen the nozzle retaining nut, orient the opening of the boom nozzle to point straight down, then retighten the nozzle retaining nut.

Hitch pin (not included)

Boom nozzle

Nozzle retaining nut

Step Fourteen: Connect remote switch to vehicle battery

WARNING

Batteries are hazardous because they contain caustic acid, can emit explosive gases, and can cause electric shock.

Caution must be exercised when making connections to a battery to avoid shock and contact with the acid, and to prevent any sparking that could lead to an explosion.

ALWAYS followthe safety instructions and steps listed below in exact sequence when connecting the sprayer’s remote switch to the battery terminals.

Page 15

Image 15

North Star MTBSL Step Thirteen Attach sprayer to vehicle, Step Fourteen Connect remote switch to vehicle battery

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended Use Chemical Application Safety Summary of Important Safety InformationDuring Assembly General Chemical Safety Towing Safety Chemical accident procedures Differently with filled sprayer attached Unpacking Closely inspect all contents in the shipping carton Following items are found in the manual bag Unpacking the Manual Bag Step Three Attach the cart base to the sprayer AssemblyStep One Attach the tongue to the cart base Step Two Attach the hitch mount to the tongue Step Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart base Step Six Attach boom arms to the boom bracket Step Ten Attach drain cap to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Nine Attach gun clips to tank Step Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pump Step Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle battery Connected to the battery Working condition Step Fifteen Check and test completed assemblyCheck and test completed assembly Check assembly Machine Components General Chemical Safety Operation Important Safety Information After Spraying Chemical Application SafetyBefore Spraying During Spraying Towing Safety Inhalation Important safety rules Operation Preparing the Sprayer for Each UseInspect Inspect and test the sprayer thoroughly Repair Operation Using the Sprayer Step One Assess wind conditions and clear work areaSpray because the wind is too strong Fill the sprayer using the following steps Step Two Fill the sprayerEnsure tank is flushed of all chemicals from prior uses Fill tank Check drain Review safety Step Three Operate the sprayerBegin agitation if Adjust nozzle Squeeze trigger & To spray, squeeze the gun triggerUnfold one or both boom arms as required Ensure uniform coverage Ensure correct spray pattern Launder Step Four Clean sprayer and decontaminate after useDrain tank Decontaminate Add antifreeze StoragePreparing for storage Removing from storage Before attempting to service the sprayer Troubleshooting Any Questions, Comments, Problems or Parts Orders Specifications Part# Description Model Qty Exploded View 28517/28518 Rev. L Height Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Spray Pressure

North Star MTBSL owner manual Step Thirteen Attach sprayer to vehicle

Models: MTBSL

Assembly (continued)

Step Thirteen: Attach sprayer to vehicle

Step Fourteen: Connect remote switch to vehicle battery